You must send the following items to Hondata:

ECU
Cashier's Check or Money Order (no personal checks)
A signed copy of this form

Customer (this is the address the ecu will be shipped back to)

Name
Address
City & State
Zip
Email
Phone

Socketing Service & Cost

Note that if the previously socketing has damaged the ECU (lifted pads or tracks), it may not be possible the change the socket to s300 pins.

Type of ECU

Engine Type & Transmission	(example B16A2, B16A1, B18B, B18C1, B18c5...auto or manual)
ECU Serial Number	(located on the ECU bar code underneath '37820-P28-A01')

ECU Type

P28 (OBD1 VTEC) P72 (OBD1 VTEC) P30/P61 (OBD1 VTEC) P06 (OBD1 Non-VTEC) PR4/P74/P75 (OBD1 Non-VTEC) P08J (OBD1 JDM VTEC) P72J (OBD1 JDM VTEC -3 plug manual only)

Repairs

An RMA number must be obtained from Hondata prior to sending any ecu for diagnostics or repair.  All Diagnostics carry a minimum $100 charge.  If the ECU you send is damaged, you will be notified. Any repair carries a minimum charge of $100 in addition to the socketing charge. There is no guarantee that damage can be successfully repaired. We suggest that the ECU be tested before shipping to Hondata. This $100 includes return shipping. Repairs are typically limited to repairing damaged tracks from poor soldering. We do not repair ECUs that give sensor codes.

Buyer releases Hondata, Inc. from any liabilities (expressed or implied, arising by law or otherwise) that may occur from the use of products sold by Hondata, Inc. and purchased by Buyer. These products are being sold for "Off Road/Competition Use" only and may be used only on vehicles used solely for "Off Road/Competition". No other applications are intended or implied. The Buyer of this product acknowledges and agrees that Seller disclaims any warranty and expressly disclaims any liability for personal injury or damages or any damages to vehicle or expensed occurred. In the event a manufacturer’s warranty exists, it is agreed and stated that under no circumstances shall the seller or manufacture be liable for any labor charged or travel time incurred in diagnosis for defects, removal, or reinstallation of this product, or any contingent expenses.  Exceeding the factory rev cut rpm may cause engine damage, which may not be covered by any factory warranty.

Damaged ECUs will be retained by Hondata to prevent the re-sale of faulty parts.

Please sign and date below to acknowledge that you have been made aware of the fact that the product that you are purchasing may void your vehicle’s factory warranty and you have been advised that this product is not EPA/CARB certified and the product is for "off Road/Competition Use" only. The Buyer will not hold any liability against Hondata, Inc. and will hold Hondata, Inc. harmless from any liability as a result of selling, purchasing and/or installing product.

Signature ___________________________________________ Date  ___________________