Looks like your meter is showing a range in kilo-ohms though, so it would be 476 Ohm for the ground, which probably is too high and an indication of a bad connection somewhere along the line.
I guess to avoid such variation from the link to the PC a workaround would be to use the on-board datalogging on a Kpro3 or higher for such power-test runs where you want the most consistent samples. That is of course under the assumption(!!) that the onboard datalogging is a real-time function of t...
Just checking, but you are starting datalogging (lightning-bolt button near top of main window, F10 on keyboard) when trying to view the sensors and calibrate the TPS, right?
Disconnect the "L" line from the K4 ECU. Most OBD readers get confused by that being present and a different ECU alltogether :) All that's normally needed is hooking E23 from the Honda ECU up to the K-line wire that was on the K4 ECU and disconnecting the L-line one (pin 73) And of course ...
Go for a little ride, and it starts missing and stumbling severely on throttle tip in. Get back home and it doesn't idle well at all again, hunting up and down. AFR all over the place. Floor it at idle and it will bog down and die. Gently ease into the throttle and it will rev fine. Do a datalog an...
Could a high or (partial) AC voltage also cause the ECU to cut out? Eg. voltage regulator or rectifier on the alternator developing an issue (often heat and vibration) and sometimes letting the voltage spike or not rectifying the AC completely anymore? Might also be a good idea to let the Kpro (if i...
The KManager help file states that: "Changing the injector size will automatically compensate the fuel tables for the rating of the injector (but not for the specific characteristics of the injector). Also the cranking fuel is compensated based on the injector size." Just curious.. Are the...
TODA A3's on K20A2 here (with matching TODA springs and chain tensioner) too and I have always had varying degrees of knock registered around 2500-3500rpm even at very low throttle openings where it really shouldn't even be able to... Tried pulling timing until ridiculous low numbers, marginal to no...
Hi, There seems to be a small bug in the GUI code or .kal parsing in 4.1.0 compared to 4.0.8 as far as I can tell. I use a PRA ECU and calibrations and with 4.1.0 some options in the Parameters section get greyed out and become un-selectable when starting Kmanager and opening an existing KAL. Especi...
OK, so the values in the maps of the calibration itself may stop it from updating the long-term fuel trim. Interesting.. At the moment my calibration is pretty spot on as far as fuel on the closed-loop areas goes (withing +/- 2%), so it won't need to trim much anyway. Will play around with this a bi...
Yup.. Constant/battery 12V (via main EFI relay coil) applied to E7. The main relay is actuated when the ECU pulls E7 to ground on detecting (ignition) power on A2/A3. DTC's are also retained across ignition on-off-on cycles. It also retains, for instance, idle valve learned positions as long as you ...