Search found 10 matches

by boosted k20
Tue Dec 16, 2014 6:01 am
Forum: s300 / SManager
Topic: wont prime
Replies: 3
Views: 1107

Re: wont prime

fuel pump capacitors need replacing. a quick fix is to cut wire A7 on the harness (Fuel pump) and ground the wire (harness side not ecu side). This will make the fuel pump be on all the time. it will not turn on and shut off. i ran several ecus like this with no problems.
by boosted k20
Tue Oct 14, 2014 4:35 am
Forum: s300 / SManager
Topic: SManager software requests
Replies: 308
Views: 107507

Re: SManager software requests

is it possible to have a rolling anti lag/2 step launch control for tx2k/mile racing? need to stop brake boosting to create boost while rolling. If you have 2-step set up as always on, I would try to wire in a push button switch and put it inline with your speed sensor signal wire to the ecu. When ...
by boosted k20
Thu Oct 09, 2014 4:38 am
Forum: s300 / SManager
Topic: Full throttlle shift
Replies: 16
Views: 6900

Re: Full throttlle shift

rev hard wrote:o ok..and how do you set it up? ''always on'' ? does that use the clutch then?
No you should wire in a clutch switch and then feed the signal from the switch to one of the inputs at the ECU. If you dont do that then your FTS rpm will be your rev limit
by boosted k20
Wed Oct 08, 2014 10:39 am
Forum: s300 / SManager
Topic: Full throttlle shift
Replies: 16
Views: 6900

Re: Full throttlle shift

You stay in boost with FTS. I did a quick datalog and with FTS i was able to stay in boost between shifts. I did a 2nd gear pull with FTS into 3rd gear. Car was at 14PSI in 2nd gear and only dropped back down to 8psi in between shifts. before i would loose all boost. With street tires i was just spi...
by boosted k20
Sun Oct 05, 2014 7:10 am
Forum: s300 / SManager
Topic: Full throttlle shift
Replies: 16
Views: 6900

Re: Full throttlle shift

Bumpppp. Spunkster is hondata looking into having FTS active only after the car is moving. A lot of us need our launch control rpm set higher than our FTS rpm. The way hondata is setup now this is not possible. Can you guys look into this for the next update. If we can have an option to have FTS act...
by boosted k20
Wed Oct 01, 2014 2:16 pm
Forum: s300 / SManager
Topic: Full throttlle shift
Replies: 16
Views: 6900

Re: Full throttlle shift

Spunkster can you please add a mph enable feature for FTS. Or have launch control take precedence over fts at 0mph? We can't rev higher than fts rpm with clutch pushed in at 0mph
by boosted k20
Mon Sep 29, 2014 10:26 am
Forum: s300 / SManager
Topic: SManager software requests
Replies: 308
Views: 107507

Re: SManager software requests

For full throttle shift, can you have a setting so that it is active after a certain speed? I am trying to set my 2-step launch control rpm higher than the FTS rpm and i cant do it. My launch rpm must always be lower than my FTS rpm in order to have both working. So what i want to end up running is ...
by boosted k20
Tue Jun 10, 2014 4:45 am
Forum: FlashPro Manager
Topic: Random CEL - 3K Rev Limit
Replies: 2
Views: 1497

Re: Random CEL - 3K Rev Limit

FYI disabling "Mass or volume circuit range performance problem enabled (P0101)" fixed the problem
by boosted k20
Mon Jun 09, 2014 5:42 am
Forum: FlashPro Manager
Topic: Random CEL - 3K Rev Limit
Replies: 2
Views: 1497

Random CEL - 3K Rev Limit

2007 SI just got tuned and everything was running good but after driving around the car for a few minutes it would throw a CEL and the rev limit would be stuck at 3K. I didnt check to see what the code was but i heard that i need to do the following: Can someone confirm... will not get a chance to g...
by boosted k20
Sat Mar 11, 2006 11:05 pm
Forum: s100/s200
Topic: Moates BURN1 chip burner
Replies: 1
Views: 1585

Moates BURN1 chip burner

if u have a tuned .bin map, can u burn the program using a moates BURN1 chip burner? Im new to hondata but i've been using uberdata for a while now. also im using sst27ST512 EEPROM chips. anyoneused them with hondata?