Hondata

Scramble boost similar to the new civic in flashpro?

Thanks for your help

The ignition is normal (see http://www.hondata.com/forum/viewtopic.php?f=12&t=16144). The AF is slow to respond, which could be from a number of causes - incorrect o2 sensor, exhaust air leak, o2 too far down the exhaust, heater not working. Thanks for the response. I thought that the ignition ...

I am having a misfire at idle and I am not sure if the oxygen sensor is going bad or if I have another problem. Can someone confir if the bahavior in the attachment for afr and ignition is normal?

Thanks

Is there any way to activate the MIL light as a shift light like the S300?

THanks

If that has to be done besides just using a conversion harness for eg/dc then I have probably not done it. I will have to check. I will let you know tomorrow.

Is there a way that the launch control would work correctly and the full shift wouldnt?

Attached my map. Please let me know what can be done or if I need to the input.
Thanks

Will do in like an hour. Thanks

I am using the first input that is listed when you activate the full throttle. I think it is the Exx? Do I have to wire something for this input to work? Or do I have to use some other input? I know I did not connect the brake input to the computer. I will have to see the parameters , but I am prett...

I am still having problems with full throttle shift. I set it to 5700rpm and that is the rpm it is redlining instead of the 8800 redline is set to.

Any help would be appreciated.
I do not have a problem with launch control.

Depending on your gear ratio you should set it to the RPM that the engine drops down to when you upshift. That way when you release the clutch your engine is already at the correct RPM to begin the next gear. If you are hitting your shift rpm limiter all the time when driving, your inputs may not b...

I do not have a problem with Launch control, but I do have a problem with Full Throttle Shift, since I set the redline at 8800 rpm and it was hitting redline at 7k rpm where I set the throttle shift to. This is on a Swapped Civic K20A EG with PRB Kpro. Also you said to set it to the lowest rpm gear ...