Search found 81 matches

by kb58
Wed Sep 24, 2014 10:29 am
Forum: K-Pro / KManager
Topic: cooling fan still always running and P0118 error code
Replies: 2
Views: 2370

Re: cooling fan still always running and P0118 error code

... and the error code P0118 ECT Sensor High Voltage..." There's your answer. The ECU is seeing an abnormally high voltage on the sensor input wire, which means that there's no continuity from that pin to ground. So either the wire's broken, the sensor connector's open, the sensing element is open,...
by kb58
Mon Jul 15, 2013 6:22 pm
Forum: K-Pro / KManager
Topic: Does KPro manage engine rpm on deceleration
Replies: 3
Views: 1669

Re: Does KPro manage engine rpm on deceleration

Hmm, okay, that's what I figured. I'd think that if there was a leak in the inlet it would cause a high idle. I have the IACV enabled, which works fine except for an odd occasional surge in idle rpm (a couple 100 rpm) which lasts a couple seconds, then it'll settle right back.
by kb58
Mon Jul 15, 2013 7:59 am
Forum: K-Pro / KManager
Topic: Does KPro manage engine rpm on deceleration
Replies: 3
Views: 1669

Does KPro manage engine rpm on deceleration

Serial number of your K-Pro- Unsure, but purchased new from Hondata about four years ago. - the calibration (as an attachment) n/a - a datalog of a problem (as an attachment) n/a - what sort of vehicle you have- one-off mid-engine turbo K24 - what sort of ECU you are using- 02-04 PRB ecu - anything ...
by kb58
Mon Apr 11, 2011 7:47 pm
Forum: K-Pro / KManager
Topic: P0123 TPS High Voltage Question
Replies: 12
Views: 4120

No way on here to PM/e-mail you, but I'll buy that TPS if you want to get some money out of it. Contact me through my sig if interested.
by kb58
Tue Apr 05, 2011 9:21 am
Forum: K-Pro / KManager
Topic: P0123 TPS High Voltage Question
Replies: 12
Views: 4120

Ok well ive fixed it, user error on my part On the Lotus ecu to set the TPS high and low points you just move the TB through its movement and the ECU picks up the max and min With the hondata you have to hold the TB at full throttle to read the upper setting, or it defaults to the lowest upper sett...
by kb58
Tue Mar 01, 2011 8:15 am
Forum: K-Pro / KManager
Topic: 02-04 stock wideband o2 voltage to AF ratio table
Replies: 2
Views: 1424

It's probably faster and more accurate to feed a variable voltage into the O2. Record both the voltage and O2 ratio and presto.
by kb58
Thu Jan 27, 2011 9:12 am
Forum: K-Pro / KManager
Topic: Help: Y Civic Wideband O2 sensor can't work w/ K-Pro
Replies: 2
Views: 1348

Use an ohmmeter and check the resistance between the wires you have connected as the heater - it should be very low, like <20 ohms. If it's higher, it's miswired. Sure sounds like it's miswired though, considering it worked with the old one and because it's complaining about a heater circuit error.
by kb58
Sun Jan 09, 2011 6:31 pm
Forum: K-Pro / KManager
Topic: Is my TPS sensor bad?
Replies: 3
Views: 1478

Correct.
by kb58
Mon Dec 27, 2010 3:28 pm
Forum: K-Pro / KManager
Topic: 04 rsx base K-pro, transferable to 02 type-s?
Replies: 3
Views: 1193

Don't know, but it's (at least) 50% the buyer's responsibility to determine that himself. Yes, knowing will help you sell it, but it's not up to you to provide tech support as to what cars it may or may not run properly.
by kb58
Fri Dec 17, 2010 11:01 am
Forum: K-Pro / KManager
Topic: ECU Wire Pin Removal
Replies: 5
Views: 5086

I found that a small jewler's screwdriver works well, available from either Home Despot or Radio Shack, and a lot cheaper than the Honda tools.
by kb58
Mon Nov 29, 2010 8:42 am
Forum: K-Pro / KManager
Topic: Serial Output - Injector Duration
Replies: 4
Views: 1244

Corrected! I understand your questions better now, but at the end of the day, does the very slight error even matter? You're off by 12 counts out of 12976, or within 0.1% of perfect, is that good enough?
by kb58
Sat Nov 27, 2010 10:33 pm
Forum: K-Pro / KManager
Topic: Serial Output - Injector Duration
Replies: 4
Views: 1244

0x0CAC = 3244 counts, and 12.964ms / 3244 = 3.996, very close to 4. 0x079D = 1949 counts, and 7.784 ms / 1949 = 3.9938, very close to 4. So it's pretty obvious that each count is 250 us [corrected: 4 microseconds], . Frankly I'm surprised that you have the sw and hw background to get as far as you d...
by kb58
Wed Nov 24, 2010 6:50 pm
Forum: K-Pro / KManager
Topic: KManager.exe infected?
Replies: 5
Views: 1751

Follow the above link and you can add an exception so that AVG keeps running for everything else except KManager.
by kb58
Tue Nov 23, 2010 10:18 pm
Forum: K-Pro / KManager
Topic: KManager.exe infected?
Replies: 5
Views: 1751

Well that's embarrassing... problem solved, thank you!
by kb58
Tue Nov 23, 2010 5:51 pm
Forum: K-Pro / KManager
Topic: KManager.exe infected?
Replies: 5
Views: 1751

KManager.exe infected?

Today when I started my PC, my AVG virus protection sw says KManager.exe is infected with "Trojan horse Dropper.Small.HQZ"

I have not updated KManager on this PC for months, so either this is the result of an auto-update from Hondata or AVG. Just thought I'd let you guys know...