Search found 21 matches

by R2Racing
Sat Nov 29, 2014 6:49 am
Forum: FlashPro Manager
Topic: RDX, huge retard at 3600-4400 rpm
Replies: 12
Views: 3843

Re: RDX, huge retard at 3600-4400 rpm

I tried zero limits, unfortunately, it does not work. Also tried to lower retards even to zero. Tried to lower sensitivity of knock sensor too. Ignition behaviour was the same. Then, decided to return to almost stock as starting point for simplicity. What does look strange there is no any knock coun...
by R2Racing
Thu Nov 27, 2014 8:41 am
Forum: FlashPro Manager
Topic: RDX, huge retard at 3600-4400 rpm
Replies: 12
Views: 3843

RDX, huge retard at 3600-4400 rpm

Hi have anybody seen a strange behaviour of ignition on RDXes such as even negative numbers up to - (minus)10 deg at 4000 rpm? Angle goes down from 3600, minimum is at 4000 rpm, and goes up then. Tried to modify all tables available for RDX, no affect. Even main ignition tables, where angle is 17-18...
by R2Racing
Thu Sep 05, 2013 12:00 pm
Forum: FlashPro Manager
Topic: FlashPro V1.6.3
Replies: 103
Views: 33057

Re: FlashPro V1.6.1

Hondata wrote:This has support for the International Accord and the Acura RDX

See FlashPro for model / part numbers.

Download here
May we hope you will find Boost Limit map for RDX?
by R2Racing
Sat Apr 20, 2013 4:35 am
Forum: FlashPro Manager
Topic: P2101 DTC and 8900 revlimit
Replies: 3
Views: 1798

Re: P2101 DTC and 8900 revlimit

really sorry, I occassionally attached one of lot of variants I tried.

btw, when I set revlimit 7000, it revvs up to 7K and no any DTC.
When I set revlimit 9500, or even 10000, it revvs till exactly 9000 rpm and , I suppose, close throttle and throws DTC after.

Attached is cal with 9500 revlimit
by R2Racing
Fri Apr 19, 2013 1:25 pm
Forum: FlashPro Manager
Topic: P2101 DTC and 8900 revlimit
Replies: 3
Views: 1798

P2101 DTC and 8900 revlimit

Hi

Civic Type-R FN2 Turbo. It has run before 9500 rev limit and everything was Ok. After couple monthes driving I'm dynoing the car of customer again and it throws DTC 2101 (Actuator throttle) after strange limit at 8900 rpm before 9500 revlimit that was set in calibration.

Any ideas?
by R2Racing
Thu Apr 26, 2012 10:29 am
Forum: FlashPro Manager
Topic: DTC P0606 PCM failure
Replies: 6
Views: 3065

DTC P0606 PCM failure

Hi Maybe anyone has seen similar trouble. Boosted R18 A/T on MAP-sensor calibration. Everything is Ok under low boosts and part-load. On boosts higher than 10 psi and after 5000 rpms we have "DTC P0606 PCM failure". It looks like fuel cut-off and DTC jumps within 1-2 seconds after. The only suspicio...