No, didn't thought of using alpha n
was trying to use MAP
Search found 20 matches
- Fri Nov 16, 2018 6:55 pm
- Forum: FlashPro Calibrations
- Topic: Intake manifold pressure changed with 4 throttle setup
- Replies: 2
- Views: 1710
- Thu Nov 15, 2018 9:47 pm
- Forum: FlashPro Calibrations
- Topic: Intake manifold pressure changed with 4 throttle setup
- Replies: 2
- Views: 1710
Intake manifold pressure changed with 4 throttle setup
hi all, recently undergoing a project of my friends car with a 4 throttle intake system setup. However, we found that the MAP reading changed to higher pressure from stock setting when plug in Hondata FP with last tuned running map as this setup base map for tuning. The idling MAP pressure changed f...
- Thu Oct 25, 2018 5:42 am
- Forum: Civic Si 2006-2011 Americas
- Topic: Closed loop parameter settings
- Replies: 4
- Views: 2497
Re: Closed loop parameter settings
After reading your reply, I have created a table as the image attached.
I set slight leaner cruising from the value 14.3 got from my wideband .
Refer to my image, I would likw to know am I correct?
Hope to have guidance and thanks alot
I set slight leaner cruising from the value 14.3 got from my wideband .
Refer to my image, I would likw to know am I correct?
Hope to have guidance and thanks alot
- Thu Oct 25, 2018 12:38 am
- Forum: Civic Si 2006-2011 Americas
- Topic: Closed loop parameter settings
- Replies: 4
- Views: 2497
Re: Closed loop parameter settings
Understood.
If say the target value was set at 14.30, does this mean that the ecu will control F.trim not lesser or highet than 14.30?
And if the ECT was set 14.6 at 80 degree C, does that mean that any temp on 80 or above, the ecu will control AFR not above or lower 14.6?
Thanks for the guidance
If say the target value was set at 14.30, does this mean that the ecu will control F.trim not lesser or highet than 14.30?
And if the ECT was set 14.6 at 80 degree C, does that mean that any temp on 80 or above, the ecu will control AFR not above or lower 14.6?
Thanks for the guidance
- Wed Oct 24, 2018 10:53 am
- Forum: Civic Si 2006-2011 Americas
- Topic: Closed loop parameter settings
- Replies: 4
- Views: 2497
Closed loop parameter settings
Hi , nice to join in the forum and I'm new to Hondata flaspro which it is current running on my k20 engine. Just would like to understand more on Hondata which I am unclear in the closed loop setting. Hope I can get guidance from all the pro here. My setting current is using by default TPS WOT, but ...