Hondata

My speed sensor 78410-S5T-901 http://i32.tinypic.com/s4tbna.jpg My gear NPR3 1 3.226 2 2.130 3 1.517 4 1.212 5 0.972 6 0.780 final drive 4.105 http://sasacom.users.photofile.ru/photo/sasacom/3297119/xlarge/211551946.jpg Speedometer Drive 41312-PE6-310 Honda CTR JDM 4.764 Сar used in races on the mil...

I understand.

What might be an idea?

Hondata
Have you ever had the problem when speed sensor turns off after car reaches 250km/h? ( 155 mph)



My speed sensor 78410-S5T-901
What could be a solution changing to some alternative more reliable sensor?
Thank

Downloaded the newest beta this morning with the new ethanol content settings; thanks again for that. Is it possible to add ECT and IAT parameters to the Generic Output criteria? Thank you! I also requested add activation intercooler sprayer for air temperature http://sasacom.users.photofile.ru/pho...

thanks

bingo

What's next?

ok

This table allows the ignition timing to be altered by gear. Positive values will advance, negative values will retard. Note that the ignition timing is change for all load and rpm values in each gear. We have an issue: ignition timing not working for all gears and does not matter which racing maps...

I do feel the filtering can smooth it over a bit, and make the signal more consistent. Can we perhaps have access to the filtering of the signal? What would be cool is just to use the last flex content value after a certain MAP threshold is hit. One can assume the E content isn't changing in boost/...

I need an electronic throttle in S300 and K-Pro, and also in some table data if it is possible to embody this project with throttle in Hondata.




Thanks you

Hondata
when would be possible to tune air fuel ratio by gears?


this applies to all models of Honda

add activation intercooler sprayer for air temperature

The ECU you have should work to control boost when wired correctly. One wire on the solenoid goes to ground, the other goes to B2 on the ECU. Make sure that it is no longer connected to whatever it went to and just from the ECU to the solenoid. I contacted them and got the answer Hello You need a U...

spunkster I checked another turbo fn2 at ECU 37820-rsp-e02 B2 boost control does not work with it too. Here in Europe there are several models of ecu for FN2 37820-rsp-e03 37820-rsp-e12 I will try to find them and here is interesting moment in england version of FN2 turbo http://www.reelmotion.co.uk...