Hondata

In order to better understand what I am working with, I have to try and learn about every feature offered by the software. I appreciate your response.

Well, I'll be damned. Thanks once again for some fabulous tech support from Hondata.

It appears to react faster than my stock ECT sensor, so I would say you will be fine. But I have no scientific evidence to back that up. You could test it.

Yes I can read. "This controls the rpm point where the injectors are cutoff at very low throttle openings. " OK so. I have moved it up to 2000 and down to 1000 and really can't tell any difference when I change it. If you let off the throttle and let it coast down to the point past where t...

If you go up to the Options tab and select settings the contents have changed.

With earlier versions you had the following tabs:

General
Units
Display
Wideband Lambda
Autotune

Now the Settings window is different.

What happened to the "settings" tab that allowed me to change what units my display shows? Also what happened to the ability to change the column units.

I can't leave well enough alone.

Been doing some figuring and looking at running eight injectors from the S300. I can use a relay to trigger power supply to four extra injectors and run them in series. Using stock injector drivers to break ground for all eight injectors. Now there are two options for the relay injector operation, o...

How old is the computer? Check the driver date on your USB controller. its under the Device manager.

You need to make sure you have a USB 2.0 or better to keep up with the data transfer rate. I had the same problem with my Dell. I added a PCMCIA card with a better USB port on it and haven't had any problems since.

Check your valve adjust.

I have all of my temp corrections set to zero for air above 60F and water above 160F for now. I will go back and adjust once I finalize the map. Although I have noticed a couple of things missing from the new version: What happened to under the settings window: Amount of fuel and timing change? Sett...

I was wondering if there were some sort of other function or code in the base ECU that was altering timing. But what concerns me the most is there are places where it is up to 10 degrees higher in the datalogs than the maps. I want to add timing but I am afraid of going to far. I see what I programm...

Doing some datalogging last night and upon review I noticed that the timing shown in playback differs from what the table shows. Apparently this only happens on the Second map. The primary map appears to follow the tables correctly.

Posted below are the data log and bin.

You don't need to run 550CC injectors in NA trim. Put the stock injectors back in.