Hondata

BTW: Same Bug with USB 3.0!

Is there a tick by the FlashPro on the status bar? What is the exact sequence of events to reproduce this? Yes, see here (my status bar): status.JPG "Power" and "USB" -LEDs always on, "Datalog" -LED is light flashing. This is the sequence of events to reproduce this as...

New bugs in 2.7.5.0, look here:
https://www.hondata.com/forum/viewtopic ... 884#p92884

Bug in the new Software 2.7.5.0 / Firmware 116: If i plug in my Flashpro via USB 2.0 (3.0 not testet at this time), i cant see anything in the Flashpro window under "Flashpro" and "Calibrations" (i can not upload a new calibration to the Flashpro and the window is empty!) like th...

Hondata wrote: ↑Thu Jun 22, 2017 1:37 pm We've made a change for the next release. We expect that release to be tomorrow.

Nice, thank you!

Can you provide the calibration? Either here or to support@hondata.com. Also can you use the 'send support information to hondata' function with the FlashPro plugged into the vehicle. Ok, now i have send you a email to support@hondata.com. And i have made "send support information to hondata&q...

Can you give a detailed method to reproduce this? We have tested and found no issue. In this case, the problem exist (every time): [/u] 1. Plug Flashpro into the OBD2 Port. 2. Start engine. 3. The car is parked (without movement). 4. Start datalog (with the datalog button). 5. The datalog LED is fl...

Today i have tested it again with the Software 2.7.4.0 and Firmware 115, but the problem still exists!

Do you have a datalog of this issue?
What supercharger do you have?

Many problems/bugs and improvements were still not accepted, look also into the request thread!

Add basic fuel overrun to fine tune the throttle response. ... And it make it possible to create fun calibrations to WIN noise level tests ... And push the repair shops and engine replacement parts :-D For example: At slower speed (specially in urban traffic or in stop and go traffic) at low speed ...

I've been waiting long enough!
Is there a bugfix for this error now?

Spunkster wrote: ↑Thu Jun 08, 2017 4:48 pm We are looking into this.

Ok, thank you!

Any news about this issue/bugfix?

Yes we have pulled codes everytime and they have been different everytime. Here are last Friday's codes. As soon as outside temperature warms up it goes out of limp mode and runs like a champ P0102 P0141 P0340 P1298 P0102 = "MAF Sensor Circuit Low Voltage" P0141 = "Secondary HO2S (Se...

Spunkster wrote: ↑Thu Jun 08, 2017 9:40 am What is the serial number that is on the FlashPro?

Car: Honda Civic TypeR, FN2
ECU-Part-Number: 37820-RSP-E03
Flashpro-Seriel-Number: FP-SI-INT-21153