Boost Control Solenoid Connector

Hondata model coverage & ECU application questions.
Post Reply
DC5teggi
Posts: 5
Joined: Mon Apr 23, 2018 12:59 pm
Location: South Carolina
Contact:

Boost Control Solenoid Connector

Post by DC5teggi » Wed May 09, 2018 5:42 pm

Just thought I would share this for anyone who may be interested.

Per the recommendations I gathered on this forum and others, I planned to wire my boost control solenoid on my 2003 Acura RSX Base (K20A3) to the purge valve wiring. Rather than cutting and splicing, I took a gamble on an alternate approach.

Ballenger Motorsports sells two connectors that appeared to be the same size as the RSX purge valve. I purchased pigtail connector CONN-85746 and can confirm that it mates properly with my stock wiring. See attached for confirmation (my retaining clip snapped off long before I tried this, but the connector would fit just fine if it was still there).

Below is a direct link to the one I purchased, for anyone interested.

https://www.bmotorsports.com/shop/produ ... ts_id/1725

Hope this helps someone!
You do not have the required permissions to view the files attached to this post.
2003 Acura RSX - K20A3
PND ECU with K-Pro v4

User avatar
Hondata
Site Admin
Posts: 8546
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Boost Control Solenoid Connector

Post by Hondata » Fri May 11, 2018 4:16 pm

Good information, thanks.
Hondata

Post Reply