Hondata • View topic - Socketing issue with JDM ecu

View unanswered posts | View active topics

Board index » General » Applications

All times are UTC - 8 hours [ DST ]

Socketing issue with JDM ecu

Page 1 of 1

[ 4 posts ]

Previous topic | Next topic

Author

Message

OTT

Post subject: Socketing issue with JDM ecu

Posted: Tue Dec 02, 2008 2:16 am

Joined: Wed Sep 15, 2004 7:48 am
Posts: 62
Location: Yorkshire, England

Hi Ive socketed half a dozen JDM ECUs with no problem before but I have one no and a row of the six pins are not functioning.

as you look at the picture of a JDM ECU in your help-file for Smanager,
on the lower row of pins, the first two pins are fine, the next six are not illuminated, and the nex six are fine.

could this be relative to the latch-IC in IC4? ...since I desoldered the bad pins, cleaned the contacts, then re-soldered them and yet I still have the same issue. ?

Top

Spunkster

Post subject:

Posted: Thu Dec 04, 2008 12:16 pm

Site Admin

Joined: Fri Sep 20, 2002 5:06 pm
Posts: 11205
Location: Hondata

Does it work correctly with the s300?

Top

OTT

Post subject:

Posted: Sat Dec 20, 2008 12:06 am

Joined: Wed Sep 15, 2004 7:48 am
Posts: 62
Location: Yorkshire, England

I have not tested it in a vehicle because of the 6x none-illuminated LEDs.

What do you suggest?

Top

Spunkster

Post subject:

Posted: Mon Dec 22, 2008 10:30 am

Site Admin

Joined: Fri Sep 20, 2002 5:06 pm
Posts: 11205
Location: Hondata

Try it with the s300 in a vehicle.

Top

Page 1 of 1

[ 4 posts ]

Board index » General » Applications

All times are UTC - 8 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: