Page 2 of 2
Posted: Fri Feb 12, 2010 2:13 pm
by Spunkster
no just the 2 listed
Posted: Sat Feb 13, 2010 5:15 am
by Honda9ower
Thanks, it was a bit of a daft question after looking at the ECU. What looked like 4 resistors in the photo is actually the 4 solder pads, 2 for each resistor.
Anyway, removing the resistors fixed it. I can now log the ELD voltage down to 0.1V. Thanks for the assistance, I'm now off to do a bit of (full wideband!) tuning.
Posted: Sat Feb 13, 2010 6:24 am
by JustinC
Finally a solution, I think hondata should make this information a sticky for people having similiar issues.
Posted: Sun Feb 28, 2010 2:37 pm
by The Spectacle
I can also confirm this fix works. Hondata, please add this to your FAQ/help file for others
Posted: Fri Mar 19, 2010 12:46 pm
by SPOOLIN
my plx is being tricky to get it to read right on hondata, so i guess in general, removing those resistors will help anyways?
What ive noticed is that the response on the s300 display for the wideband is slower than the actual wideband, shouldnt it be just as responsive and quick as the actual plx display?
Posted: Sun May 09, 2010 12:37 am
by bewize
will that work the same on PRA ECU (EU EP3)?
and why there aку 2 resistorsб not 1?
removed resistors
Posted: Sat May 22, 2010 7:28 am
by camoy
So just to be sure after I removed the resistors I can leave the circuit open? I don't need to solder a wire back in the resistors place?
Re: removed resistors
Posted: Sat May 22, 2010 7:30 am
by The Spectacle
camoy wrote:So just to be sure after I removed the resistors I can leave the circuit open? I don't need to solder a wire back in the resistors place?
correct
Posted: Mon Mar 21, 2011 3:49 pm
by rkhan
I am having the same problem on my PRA ecu with PLX AFR wideband.
How many have tried this and worked?
This is a bit tricky
Posted: Mon Mar 21, 2011 3:50 pm
by The Spectacle
It works, trust me.
Re: Can't datalog PLX wideband below 1.2V
Posted: Mon Jan 07, 2013 12:16 pm
by 93supercoupe
this should be stickied. Furthermore, Hondata should tell people about this when a customer calls with a similar issue.
Re: Can't datalog PLX wideband below 1.2V
Posted: Tue Jan 08, 2013 9:07 am
by Hondata
It depends on the output current of the wideband. Most are ok.