Kpro4 AC problems CTR EP3 Euro

K-Series Programmable ECU installation questions / support issues
Post Reply
CivicVTi
Posts: 313
Joined: Mon Dec 15, 2003 1:51 pm
Location: Athens, Greece

Kpro4 AC problems CTR EP3 Euro

Post by CivicVTi »

Hello. Have noticed that with KPro4, the AC or EPS idle routines do not work as in older Kpro boards. When first engaging AC or turning the steering wheel (especially with the AC on), engine almost stalls. Please find attached calibration and datalog.

***Edit: Some more information. Car was running perfectly well before soldering the Kpro4. So it can't be the idle valve. I have also seen this problem in another Kpro4 equipped PRA but at that time, I did not pay attention as I thought it was the car's problem (or a faulty idle valve or the AC compressor faulty, drawing more power). Engine almost stalls when turning the steering wheel (PSP lights up correctly on the log though).
Attachments
idle AC problem.kdl
(208.17 KiB) Downloaded 180 times
2015.08 ep3, i-h-e, PRC.kal
(163.08 KiB) Downloaded 165 times
Justinthecoastie
Posts: 27
Joined: Fri May 09, 2014 3:45 pm

Re: Kpro4 AC problems CTR EP3 Euro

Post by Justinthecoastie »

What worked for me, as Hondata hasn't responded yet, was setting the idle valve control to its highest setting. I slid it all the way to the right and so far it hasn't died on me.
LK7R
Posts: 127
Joined: Wed Mar 05, 2008 12:48 pm
Location: Prague / Czech Republic
Contact:

Re: Kpro4 AC problems CTR EP3 Euro

Post by LK7R »

Just writing for confirmation that this has been fixed in version 4.1.5.
Post Reply