Page 1 of 1

S2000 kpro wiring for race car

Posted: Tue Jun 13, 2017 7:55 am
by Malkolm666
Hi, Im building a race harness for a track car. It has a F20c engine and a PRB ecu with kpro v4 build for the s2000.

The owner has lost the harness for the new Camsensor and Cranksensor. What pinout should I wire them to?

We have a RSX primary wideband lambda, what do I need to do to make it work?
(In the manual you say that to use a narrowband and change settings to use secondary lambda in kpro).

Thanks!
/Malkolm

Re: S2000 kpro wiring for race car

Posted: Tue Jun 13, 2017 9:11 am
by Hondata
Can you give us the KPro serial number and the ECU serial number?

You can't use the RSX wideband. If you want a wideband then use an aftermarket wideband and feed the output in the ECU or the KPro.

Re: S2000 kpro wiring for race car

Posted: Tue Jun 13, 2017 10:27 am
by Malkolm666
2054-101582

43342

Re: S2000 kpro wiring for race car

Posted: Tue Jun 13, 2017 11:54 am
by Malkolm666
Please respond asap, car is supposed to go on the dyno tomorrow. Ive already wired in a innovate gauge and lqmbda to the kpro.

Now its just the cam & crank sensors I need to wire correctly.

Re: S2000 kpro wiring for race car

Posted: Tue Jun 13, 2017 4:47 pm
by Hondata
Replied to your emails.

Re: S2000 kpro wiring for race car

Posted: Tue Jun 13, 2017 5:51 pm
by Malkolm666
Thanks!

Re: S2000 kpro wiring for race car

Posted: Wed Jun 14, 2017 5:04 am
by fonzeka
Second S2000 with Kpro here in Sweden? Nice :)