Injector driver question

K-Series Programmable ECU installation questions / support issues
Post Reply
BongoBennie
Posts: 33
Joined: Fri Jun 18, 2004 12:40 pm
Location: vegas
Contact:

Injector driver question

Post by BongoBennie » Thu Aug 03, 2017 5:41 pm

I'm interested in building a bi-fuel car using Kpro and injector driver using CNG as main fuel and e85 for higher powered driving. My question is could I write a program that would run ONLY on the secondary injectors were I to run out of gas or for what ever reason wanted to run only on e85?

User avatar
Hondata
Site Admin
Posts: 8728
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Injector driver question

Post by Hondata » Fri Aug 04, 2017 8:31 am

No, the software was designed to run staged injectors where either the primary injectors are running, or both the primary and secondary injectors.
Hondata

BongoBennie
Posts: 33
Joined: Fri Jun 18, 2004 12:40 pm
Location: vegas
Contact:

Re: Injector driver question

Post by BongoBennie » Wed Apr 03, 2019 4:26 pm

1.5 years later and were at this again.

With 2 injector drivers can driver #1 run low impedance main injectors and driver #2 run secondary additional set? Run with Kpro v4

User avatar
Hondata
Site Admin
Posts: 8728
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Injector driver question

Post by Hondata » Thu Apr 04, 2019 12:11 pm

The KPro can only run high impedance injectors. If you ran a second set of injectors then they can be either off or on but the KPro controlled injectors will always be running.
Hondata

Post Reply