KPro v4 Firmware Upgrade Issues

K-Series Programmable ECU installation questions / support issues
Post Reply
timot_one
Posts: 11
Joined: Sun Nov 21, 2010 10:20 am
Location: Dayton, OH
Contact:

KPro v4 Firmware Upgrade Issues

Post by timot_one » Tue Jun 18, 2019 8:28 pm

I have a KPro v4 and am using KManager 4.4.1. The issue that I'm experiencing is that I get a pop up window when opening KManager while connected to my KPro that says "The KPro firmware will be upgraded". It shows that the USB Driver is installed, the ECU is On Line and the Ignition is on, but as soon as I click OK the ECU status changes to Off Line. There is no status showing any progress of the firmware update and nothing happens. I also noticed that when this happened, all of the information to my CAN display goes blank.

What can I do to correct this issue? I am unable to connect my laptop to my KPro to make changes.
Timothy CM55 K24A2 TVS2300

User avatar
Spunkster
Site Admin
Posts: 17850
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: KPro v4 Firmware Upgrade Issues

Post by Spunkster » Wed Jun 19, 2019 9:06 am

Disconnect any analog and digital inputs before updating the firmware as they may be interfering.

timot_one
Posts: 11
Joined: Sun Nov 21, 2010 10:20 am
Location: Dayton, OH
Contact:

Re: KPro v4 Firmware Upgrade Issues

Post by timot_one » Wed Jun 19, 2019 9:12 am

Thanks for the suggestion. I will disconnect all digital and analog inputs when I get back to the car later this week.

Is there a status bar that shows the progress of the updates, or anything that will indicate the updates are complete?
Timothy CM55 K24A2 TVS2300

User avatar
Spunkster
Site Admin
Posts: 17850
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: KPro v4 Firmware Upgrade Issues

Post by Spunkster » Wed Jun 19, 2019 10:49 am

Yes it will show it updating the firmware and disappear when done.

timot_one
Posts: 11
Joined: Sun Nov 21, 2010 10:20 am
Location: Dayton, OH
Contact:

Re: KPro v4 Firmware Upgrade Issues

Post by timot_one » Wed Jun 19, 2019 11:35 am

Thank you for confirming that for me. I will be following up at the end of the week with my results.
Timothy CM55 K24A2 TVS2300

Post Reply