Hi,
Is there a torque limiter set in Kmanager as default? Just working on a supercharger tune at it hits 260 LB/FT and flattens out.
Torque limiter
Re: Torque limiter
No, there is not.
Re: Torque limiter
That's strange then?
It literally hits 260 lb/ft and table tops out. BHP carries on up fine for 400
Would you have an idea on what this is?
It literally hits 260 lb/ft and table tops out. BHP carries on up fine for 400
Would you have an idea on what this is?
Re: Torque limiter
There is nothing in the software that would specifically limit torque. This would have to do with the parts involved, and issue with timing/fuel, or an issue with the dyno.