NEED HELP WITH MY TPS!!! reading high voltage

boosted crx-r · Post by **boosted crx-r** » Sat May 09, 2009 4:54 am

my TPS reads 2% open when i am idling without pressing the gas pedal and 113% at wide open throttle followed by CEL for TPS high voltage. What is going on here? How do I fix it??

Garrett_si · Post by **Garrett_si** » Sun May 10, 2009 4:30 pm

calibrate it

boosted crx-r · Post by **boosted crx-r** » Sun May 31, 2009 2:57 pm

found where to calibrate it and everything is working good now. thanks

savageevo · Post by **savageevo** » Fri Jun 05, 2009 10:57 pm

i am having the same problem, where and how do you exaxtly calibrate it thanks all

Post by **Spunkster** » Mon Jun 08, 2009 11:49 am

Load your calibration into Kmanager, then with ignition on (engine not running) and datalogging, go to the Knock/TPS tab in Parameters and click read (minimum) with the throttle fully closed, then go wide open throttle and click read (maximum) a then upload the calibration.

savageevo · Post by **savageevo** » Mon Jun 08, 2009 10:18 pm

thanks spunker, just did it and it works