Hondata

What kind of injectors size was the johnnytune done with? What about with RDX 410cc injectors?

all BASEMAPS strock inj unless noted otherwise. Never tried RDX but heard nothing but great things.

Could prolly run a safe 50 shot SURPRISE with those.

Is there a calibration on here with the rdx injectors?

I have a similar setup to the original poster. I am currently running the Toda basemap found in Kpro. Car runs pretty good, but also pretty rich at WOT, 11.8-12.3 . How does the map on page 1 compare to the Toda basemap?
I plan to try it out in a few weeks when I get back in town. I lost to a new 2011 5.0 by a couple cars and need more power. :0

What is up with that fuel dip at 5500 RPMs?

i need some to take a look at this tune and see if they can set it. i installed a set of rdx 410 injectors and im having some cold start problems, it takes several cranks to get it going but after it warms up everything works ok.
mods: k20a3 block, a2 pistons, rods and crank, cc stage 4 clutch kit with light wieght flywheel, k24a2 head with stock cams and skunk2 high comp valves, retianers and springs, rdx 410 injectors, dcrh, costum 3in cai and costum 3in exhoust.
im running the first tune keto posted on this thred so if any one can take a look and let me know.

WOW thats a frankenstein setup! Definitely didnt design the kal for that! Get that EP3 to a tuner, PRONTO!

hey keto i dont know if u still frequent this forum and thread but im going to try out the kal u had on your first post i have a 2002 k20a2 with injen cold air intake, rbc manifold, hondata img, strup shorty header, t1r test pipe no cat, invidia q300 exhaust and some lightweight pullies could you help me with a tune?

I dont know if YOU still frequent this forum but use the kal from this thread. Avoid race header kals. They wont work with the shorty/test pipe combo. And post a log already!