Problem I Keep Having (Cranny?)

K-Series Programmable ECU Calibration updates / downloads
Locked
keto06
Posts: 499
Joined: Fri Jul 17, 2009 9:29 pm

Problem I Keep Having (Cranny?)

Post by keto06 » Thu Sep 10, 2009 1:01 pm

This is prolly the 3rd-4th time Ive had this problem.

I will do a pull, and I will get an AFR reading like this. If I try and remove any fuel from the maps, it will hit lean cut.

As you can tell from the datalog, running this rich, the car runs very slowly.

Any help would be MUCH appreciated.

Attached is current kal and datalog.
Attachments
k20a2-cai-rh-exh-mynewfuelvalues2.kal
(47.3 KiB) Downloaded 203 times
11112.kdl
(46.42 KiB) Downloaded 220 times

cranny
Posts: 488
Joined: Sat Feb 23, 2008 9:58 pm

Post by cranny » Thu Sep 10, 2009 4:05 pm

here load this on and datalog again. any reason you have the vtec pressure switch disabled? is this a jdm engine?
Attachments
k20a2-cai-rh-exh-mynewfuelvalues2.kal
(50.63 KiB) Downloaded 199 times

keto06
Posts: 499
Joined: Fri Jul 17, 2009 9:29 pm

Post by keto06 » Thu Sep 10, 2009 4:49 pm

its USDM but the sensor randomly throws a code so I disabled it.

Locked