ukdm ep3 turbo map
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
ukdm ep3 turbo map
hello i have a 2003 civic type r turbo running a t4 turbo, kpro ecu 650cc rc injectors i need a map to drive on while i run the new pistons and bearings in can anyone help me ? thanks in advance.
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
anything ?
Can anyone give me something to even get the car drove to the mapper ??.
Can you not use the PRB maps? i
Give this one a try and see if it works.
Give this one a try and see if it works.
- Attachments
-
- 650turbomap.kal
- (51.96 KiB) Downloaded 333 times
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
keto i dont understand what your doing here. maybe you guys dont read well , THERE IS NO MAP YOU CAN LOAD ON AND SIMPLY DRIVE DRUMMER. pick one of the calibrations in Kmanager that closely matches you setup , set any parameters that may be different. go for a drive in closed loop , datalog it see how it runs. make adjustments.
actually list your entire setup for me pal.
actually list your entire setup for me pal.
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
-
- Posts: 17
- Joined: Sun Sep 27, 2009 3:11 pm
- Location: n.ireland
done it there back and forth and changed the tables starts fine sounds good all lights out so all good so far. with the prb map in it was throwing up internal error in ecu must have been because the differences in lambda sensors. i will post back when i get a datalog sorted out, once again thanks alot.