Hello,
I am trying to tune each cam angle. I have already read a lot of posts, understand the techniques, watched the training videos. The problem I am having is that I can't get rid of the knock on a cam angle map. I started with the 0 low cam map, started WOT pull and knock started instantly at 2000 to 3500. I pulled, and added 2 degrees in that area but could not get rid of the knock. Do I just keep pulling ignition? I have attached the kal and datalog. Any help is appreciated.
Setup:
K24A2
50* VTC
CAI
JRSC 3.0 Pulley
Aftercooled
Short Header to 2.5 test pipe and mid pipe. Type R muffler.
Need help tuning cam angles
Need help tuning cam angles
- Attachments
-
- 0 cam low.kdl
- (221.31 KiB) Downloaded 275 times
-
- 0 low cam.kal
- (49.88 KiB) Downloaded 285 times
-
- Posts: 35
- Joined: Mon May 24, 2010 2:25 pm
- Location: South San Diego
-
- Posts: 49
- Joined: Fri Dec 08, 2006 6:08 pm
- Location: Port Allen
- Contact: