Page 1 of 1

s300 CEL stays on. both green and red LED's stay on

Posted: Mon Apr 07, 2014 9:59 am
by ef8904
I was replacing the motor in my crx (B20 BLOCK TO LS BLOCK) and thought i was ready to start the car but evidently forgot the ground to chassis since i have the battery relocated in the back. the battery was grounded by the tail lights. and the harness was grounded to the thermostat housing. so who do i send it to or what do i look for burned up?

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Mon Apr 07, 2014 10:02 am
by ef8904
the car was running fine last week. and i only realized i had a problem when i clicked to acc and smanager was telling me i only had 10 volts

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Mon Apr 07, 2014 10:46 am
by Spunkster
Use a multimeter and check the voltage from the battery to the ECU and find where the voltage is droping. Relocating the battery typically causes more problems than it solves.

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Mon Apr 07, 2014 2:48 pm
by ef8904
I dont believe there is still a voltage issue because i plugged my s300(p72) into a 94 civic 5spd and i still cant get any signal to smanager. turn key to acc and fuel pump primes, CEL stays illuminated. and i still cannot datalog.

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Mon Apr 07, 2014 3:21 pm
by Spunkster
What happens when you try to upload to the s300?

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Tue Apr 08, 2014 4:45 am
by ef8904
Would not let me upload. I pulled my module off and i see where it has a short =/ how much to fix or upgrade to version 3 if its an option still?

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Tue Apr 08, 2014 9:30 am
by Spunkster
Post a picture of what you see.

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Tue Apr 08, 2014 9:33 am
by ef8904
Heres a pic

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Tue Apr 08, 2014 3:32 pm
by Spunkster
Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions (include a link to this thread):

Name:
Address:
Phone:
Email:
Serial#:
Description of problem:

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Tue Apr 08, 2014 4:02 pm
by ef8904
oops read that to fast. i gotcha. thanks!

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Thu Apr 17, 2014 4:06 am
by ef8904
"how much to fix or upgrade to version 3 if its an option still?" .. you never contaced me with any options. you simply charged me $250 to replace the board back with a version 1??

Re: s300 CEL stays on. both green and red LED's stay on

Posted: Thu Apr 17, 2014 4:02 pm
by Spunkster
replied via email