Boost by gear setting

s300 and SManager software questions & answers
Post Reply
picnic_george
Posts: 54
Joined: Tue Feb 14, 2006 1:33 am
Location: Sparks, NV

Boost by gear setting

Post by picnic_george »

There is an option to use a pressure vs duty cycle setting and gear based duty cycle(which ignores the pressure vs duty cycle). Any reason one would use pressure vs duty cycle over gear based? If I want 15 psi what do I care what the solenoid duty cycle is at to acheive that? I know it's nowhere near maxed out.

User avatar
Spunkster
Site Admin
Posts: 18625
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Boost by gear setting

Post by Spunkster »

You must still setup the pressure vs duty cycle table or the ECU will not know what duty cycle will produce a certain pressure.

picnic_george
Posts: 54
Joined: Tue Feb 14, 2006 1:33 am
Location: Sparks, NV

Re: Boost by gear setting

Post by picnic_george »

So it does not ignore that setting? Why even have it then? Seems redundant.

picnic_george
Posts: 54
Joined: Tue Feb 14, 2006 1:33 am
Location: Sparks, NV

Re: Boost by gear setting

Post by picnic_george »

Gear based duty cycle

Image

This setting will output a duty cycle based on the boost by rpm & gear table. The pressure vs duty cycle table is not used with this setting.

Post Reply