Datalogs do not appear in Datalogging window
Posted: Sat Jun 20, 2015 7:09 pm
I have an S300 v2. I started datalogging a few days ago. The problem I have having is that the datalogs do not appear in the Datalogging Tab/Window, so I cannot save them (although I can export the last recording - see below).
Attached is a screen shot showing the problem. The window on the third row shows that the S300 has recorded 8.829 seconds of data. But the Datalogging tab does not list any recordings and the Datalogging Capacity says "0k" has been used. I read through the S300 User Guide and it does not say I need to do anything else for the recordings to appear in the tab.
Confirming that the recordings have actually occurred, I can "Export" the last recording and a perfectly good .csv file will be created, with 20 frames per second. I have opened three of these in Excel so far. However, only the latest recording gets exported - any earlier recordings disappear.
Any suggestions on how to get the recordings to appear in the Datalogging Tab.?
Attached is a screen shot showing the problem. The window on the third row shows that the S300 has recorded 8.829 seconds of data. But the Datalogging tab does not list any recordings and the Datalogging Capacity says "0k" has been used. I read through the S300 User Guide and it does not say I need to do anything else for the recordings to appear in the tab.
Confirming that the recordings have actually occurred, I can "Export" the last recording and a perfectly good .csv file will be created, with 20 frames per second. I have opened three of these in Excel so far. However, only the latest recording gets exported - any earlier recordings disappear.
Any suggestions on how to get the recordings to appear in the Datalogging Tab.?