Hi all.
I buy the gen 4 combo the PLX DM-6 52mm + SM-AFR GEN4 Combo PN C6AFRG4
I have civic 2000 ek4 with b16a2.
P30 JDM and hondata s300
Have a one good question.
I am new with wideband and I buy PLX sm dm6 combo becauses hondata talk very good about this product.
I need help to install the PLX and in internet I dont find nothing for civic.
I find this foto but I think the pin in ecu is not correct for my obd1.
Anoder people talk d10 other d14.
Could you tell me if this foto is good
Sorry for my bad english :)
Help Install PLX wideband
Re: Help Install PLX wideband
You may find this helpful: https://www.hondata.com/techplxwiring.html
Re: Help Install PLX wideband
Ok thx but my wideband have 6 cable. I have from bosch 4.9
Sorry for the stupid question
Have any fotos for the installation???
Sorry for the stupid question
Have any fotos for the installation???
Re: Help Install PLX wideband
You will need to look at the documentation that came with the wideband and then use the instructions we provided to wire it to the ECU.
Re: Help Install PLX wideband
Ok I try in this end week and if all work I make Fotos.
Thx for you answer
Thx for you answer
-
- Posts: 16
- Joined: Thu Aug 20, 2015 4:52 pm
Re: Help Install PLX wideband
not sure where to post this ? so its going here. I just installed the PLX wide band module gen 4 in my crx and removed the R136 and R138 resisters now I'm getting code 43 on smanager and P0169 on the hondata app. code is for Fuel Compensation and was wondering how I can fix this. I seen that my S. Fuel trim dips to -30 and that activates the cell after that is stays around 2 the a/f is at 13.22 any thoughts? Engine is spuddering while under steady throttle. I also looked at the datalog and my Short Fuel trim is all over the place. I attached a datalog to see if this helps.
- Attachments
-
- datalog 0.s3d
- (2.69 MiB) Downloaded 226 times
Re: Help Install PLX wideband
It probably needs to be properly tuned.
-
- Posts: 16
- Joined: Thu Aug 20, 2015 4:52 pm
Re: Help Install PLX wideband
yeah I figured that lol. I just got all of it put together and now it don't run right. oh well Humble is 2 hours away.
-
- Posts: 16
- Joined: Thu Aug 20, 2015 4:52 pm
Re: Help Install PLX wideband
hey spunkster did you get a chance to check out the datalog?
Re: Help Install PLX wideband
It's really hard to tell anything from just a datalog and no calibration, but it sounds and looks like it is probably just a tuning issue and once properly tuned should run properly.