Bring back the strain gauge

s300 and SManager software questions & answers
V-Spec race development
Posts: 192
Joined: Wed Aug 22, 2007 12:41 am

Re: Bring back the strain gauge

Post by V-Spec race development » Tue Jun 21, 2016 7:38 pm

rev hard wrote:yup....speedfactory sells them...jjautowerks...few others
What do u think about this?

http://www.fueltech.net/shift-knob-w-st ... d-221.html

SPOOLIN
Posts: 143
Joined: Sun Mar 20, 2005 10:47 pm
Location: North Georgia
Contact:

Re: Bring back the strain gauge

Post by SPOOLIN » Tue Jun 21, 2016 7:50 pm

Too inexpensive to be true(good)
www.MSSRACING.com
9.29 | 6.20 | 167

V-Spec race development
Posts: 192
Joined: Wed Aug 22, 2007 12:41 am

Re: Bring back the strain gauge

Post by V-Spec race development » Tue Jun 21, 2016 7:54 pm

SPOOLIN wrote:Too inexpensive to be true(good)
I think the guys at real street performance recommend this knob.
Last edited by V-Spec race development on Tue Jun 21, 2016 7:57 pm, edited 1 time in total.

V-Spec race development
Posts: 192
Joined: Wed Aug 22, 2007 12:41 am

Re: Bring back the strain gauge

Post by V-Spec race development » Tue Jun 21, 2016 7:56 pm


rev hard
Posts: 45
Joined: Tue Nov 16, 2010 5:01 pm

Re: Bring back the strain gauge

Post by rev hard » Wed Jun 29, 2016 3:59 am

i wish they would just bring back the strain gauge support....instead of this on/off bs

SPOOLIN
Posts: 143
Joined: Sun Mar 20, 2005 10:47 pm
Location: North Georgia
Contact:

Re: Bring back the strain gauge

Post by SPOOLIN » Sat Jul 02, 2016 7:12 pm

any way to add the cut timer to the input based ignition cut? Basically when the FTS is triggered via something like the vtp, it will cut for a predetermined amount of time....as to allow for just maybe blipping the clutch rather than fully using it.

Basically make the time settings for the strain gauge apply to either input method.
www.MSSRACING.com
9.29 | 6.20 | 167

Post Reply