P28 S300 - ECU voltage detection problem

s300 and SManager software questions & answers
Post Reply
Lyle_57IAL
Posts: 131
Joined: Wed Jul 25, 2012 5:42 pm

P28 S300 - ECU voltage detection problem

Post by Lyle_57IAL » Sat Mar 18, 2017 7:22 pm

Hey Hondata,

Currently have P28 S300 on a B18C Turbo Integra Dc2. Currently the ECU will not see the correct amount of voltage being produced from the battery. The floating battery voltage is around 13v as you would expected however the ECU sees this as 6.0v - and hense is messing with the injector Dead Times.

What could the possible route cause be forthis - what components (either ECU, alternator or Battery) should we be looking at etc

Cheers

Lyle

User avatar
Spunkster
Site Admin
Posts: 18080
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: P28 S300 - ECU voltage detection problem

Post by Spunkster » Mon Mar 20, 2017 9:39 am

When you measure the voltage at the ECU pins with a multimeter, what voltage do you see.

Lyle_57IAL
Posts: 131
Joined: Wed Jul 25, 2012 5:42 pm

Re: P28 S300 - ECU voltage detection problem

Post by Lyle_57IAL » Mon Mar 20, 2017 5:10 pm

Voltage going into the ECU is as expected. 13.5v or there abouts.

User avatar
Spunkster
Site Admin
Posts: 18080
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: P28 S300 - ECU voltage detection problem

Post by Spunkster » Tue Mar 21, 2017 11:00 am

Post your calibration as well as a datalog showing the issue.

Post Reply