Page 1 of 1

Bug/Issue with Highlighting Target Lambda Load

Posted: Sat Mar 17, 2018 2:46 pm
by creizlein
Found a stupid but annoying error on the Target Lambda (Load) fields on the Parameters/Closed Loop Advanced form.
The current state field/cell is no correctly highlighted (as all other tables) , its always stuck and highlight the last one.
On below screenshot you can see that the Target Lambda ETC highlight properly but the Target Lambda Load does not, it stuck on 90kpa when i am currently at only 30kpa (or 330mbar), it also doesn't move while driving.
snap0629.png
snap0629.png (85.1 KiB) Viewed 697 times
Hope your guys can review and fix that for next minor release :)