s300 and SManager software questions & answers
6 posts • Page 1 of 1
hi , im trying to figure this out , when i do full throttle under boost more than 10 psi the afr reads lean around 7k rpm twice , i have datalog when i look at it injectors stop working in a spot , no matter how much fuel i have in the table , i have attached the datalog and map , please help the head gasket is already gone i was doing a pull to record datalog and see the problem , and boom on 3rd gear i blew the engine
Are you using a strain gauge?
Why do you have it enabled in your calibration?
i actually havent noticed it , is that why its cutting fuel ?