S300 base map problems

s300 and SManager software questions & answers
Locked
D@nny
Posts: 26
Joined: Sat Sep 17, 2005 11:32 pm

S300 base map problems

Post by D@nny » Sat Sep 17, 2005 11:43 pm

Im having a problem getting a decent base map.

My setup is 1000cc RC injectors and a gm 3 bar map on a 2.0 fully built gsr motor with a gt35R

The s300 base program will not start or idle unless I add 100 percent to the overall fuel trim. then it will idle VERY lean and the map jumps all over the place from rich to lean with steady fuel pressure....

Does anyone have a 1000cc Base that works?

Silverbeast
Posts: 127
Joined: Wed May 21, 2003 12:03 am

Post by Silverbeast » Sun Sep 18, 2005 2:48 am

What you should try is taking off all the correction to begin with. The air temp and the water temp set all to 0.

I would then take the map section for idle and add fuel to it slowly. try to set the timing in these areas at about 20 degrees. Also, make sure that the correct map sensor was selected.

D@nny
Posts: 26
Joined: Sat Sep 17, 2005 11:32 pm

Post by D@nny » Sun Sep 18, 2005 11:00 am

Even with the correction down or at 0 it still gives it no fuel.....the temp correction adding fuel isnt hurting it as its running very lean....

converting the s200 rom to s300 does not work corretly either and it completely screws up the fuel...

User avatar
Spunkster
Site Admin
Posts: 18012
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster » Mon Sep 19, 2005 12:25 pm

are you using the first or last 20 columns?

Locked