s300 and additional injectors?

s300 and SManager software questions & answers
Locked
EITCP
Posts: 27
Joined: Wed Jun 15, 2005 12:45 pm

s300 and additional injectors?

Post by EITCP » Fri Nov 25, 2005 2:31 am

does hondata S300 support 4 additional injectors?

RMS
Posts: 212
Joined: Thu Nov 20, 2003 12:35 am
Location: Visalia, CA

Post by RMS » Sat Nov 26, 2005 8:13 pm

send your ecu to us and it does :)

Image

works great for the edelbrock kits. seconday injectors engage with vtec. as pictured for saturated injectors, but add a dropping resistor and no prob with low impedance injectors.
RaVer Motorsports (559) 733-4711
ravermotorsports@earthlink.net

CivicVTi
Posts: 287
Joined: Mon Dec 15, 2003 1:51 pm
Location: Athens, Greece

Post by CivicVTi » Sun Nov 27, 2005 3:58 am

Great! Do they 'accept' the same pulses with the main injectors? I mean if the tables command for a 5ms pulse, I guess the secondary's will also accept a 5ms pulse, right?

RMS
Posts: 212
Joined: Thu Nov 20, 2003 12:35 am
Location: Visalia, CA

Post by RMS » Sun Nov 27, 2005 12:18 pm

exactly. we recommend using your larger injectors as the primaries and then adding the secondaries with vtec. if it is a non-vtec app you just disable the vtp and vtec sol and use the vtec map on the non-vtec application. if you are semi-tuned and add the secondaries you just multiply the vtec map by (old injector flow rate)/(old + new flow rate)

example: for edelbrock kit with 310cc additional injectors...
240/(240+310)=240/550=.436
contol J, enter .44 in parameter window with entire vtec map highlighted.
i add 10% back to insure a rich map to begin tuning with.

stock d16y8s easily and safely produce 210-220whp (dynojet) with the edelbrock kit at 11-12psi and hondata control of the extra four injectors.
RaVer Motorsports (559) 733-4711
ravermotorsports@earthlink.net

Locked