Basemap D15Z /edm/ ?

s300 and SManager software questions & answers
Locked
rtibor
Posts: 4
Joined: Tue Jan 17, 2006 4:45 am

Basemap D15Z /edm/ ?

Post by rtibor »

Hello!
I just received the S300, could someone help me to get the Civic D15Z6 /EDM/ engine's original basemap?
It is actually OBD2B, but the new control is OBD1 /P28-ECU EDM 5 speed manual + Hondata s300/. Could someone help me how to run / operate it? I have only found D15B in the program.
Thanks!
User avatar
Spunkster
Site Admin
Posts: 22745
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

You cannot put an OBD2 program into an OBD1 ecu. You will have to start with the p28 calibration and tune form there.
rtibor
Posts: 4
Joined: Tue Jan 17, 2006 4:45 am

Post by rtibor »

Thanks, i will try it.
rtibor
Posts: 4
Joined: Tue Jan 17, 2006 4:45 am

Post by rtibor »

Could someone help me find an ignition and fuel-air chart with factory settings for my engine?
rtibor
Posts: 4
Joined: Tue Jan 17, 2006 4:45 am

Post by rtibor »

Would you please let me know which ROM should i start using with my s300 if I only have a lambda /sensor/ or o2 with 1 wire ? /not 4 wire/
because my ECU said error code 41 Primary oxygen sensor heater.
thanks
User avatar
Spunkster
Site Admin
Posts: 22745
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

a 1 wire o2 sensor will not work with an OBD1 ecu. You will have to purchase a wideband if you want to get wideband readings (such as the PLX). To run properly in closed loop with a stock sensor you must be using an OBD1 4 wire O2 sensor.
Locked