tuning question?

s300 and SManager software questions & answers
Locked
95lshatch
Posts: 3
Joined: Thu Jan 05, 2006 12:44 pm
Contact:

tuning question?

Post by 95lshatch »

this may sound stupid but im barely geting into tuning. i have a non vtec ls motor and i want to tune it my self, so that i can learn. on the smanager it says low speed fuel and ignition and than high speed fuel and ignition. from reading on this website and tutorials, that is for a vtec engine high speed fuel would be after vtec and low speed would be before vtec. since i dont have vtec should i only be tuning the high speed or low speed tables or make them both the same. IM confused please help.

locash
Posts: 289
Joined: Sat Mar 20, 2004 11:27 am
Location: Phoenix, AZ
Contact:

Post by locash »

Welcome to the forum! You should only be tuning on the low cam tables, unless you have a need for more resolution and higher rpm..

Good luck, and be careful when using the ignition tables, that is an easy way to damage a perfectly good motor..

95lshatch
Posts: 3
Joined: Thu Jan 05, 2006 12:44 pm
Contact:

Post by 95lshatch »

thanks for the awnser now i understand it better

cinq
Posts: 25
Joined: Sat Feb 14, 2004 10:15 am
Location: Philadelphia
Contact:

Post by cinq »

locash wrote:Welcome to the forum! You should only be tuning on the low cam tables, unless you have a need for more resolution and higher rpm..

Good luck, and be careful when using the ignition tables, that is an easy way to damage a perfectly good motor..
Listen to Locash...he's the man. :) Also, it's best you don't mess with the ignition tables until you know what you're doing.

Good luck learning.

Locked