Can an S100 map be used on an S300

12sechonda · Post by **12sechonda** » Fri Jan 27, 2006 11:49 am

Hi, I have already had my car tuned with an S100. I am buying a used S300 since it was a good deal. I havent got it just yet and am wondering if my fuel and timing maps can be imported into S300 tables so I dont have to have the car retuned.

-Thanks

Post by **Spunkster** » Fri Jan 27, 2006 1:18 pm

Yes, if you have the bin file that the s100 is using.

12sechonda · Post by **12sechonda** » Fri Jan 27, 2006 2:18 pm

Thats what I was thinking, so - I took the 29C256 chip out and put it in my reader, saved it, then tried to open it in the S300 software and it does not open properly. I dont think I would have to get any data off the S100 unit?

The program should be stored on the 29C256, right?

Here is a link to my bin, maybe someone who can read S100/S200 code can open it?

http://www.ashtabularacing.com/Temp/mar ... 61_15p.bin

Post by **Hondata** » Mon Jan 30, 2006 9:25 am

Read your EEPROM again - the file in the link is only 1 byte long, whereas it should be 32768 bytes long.