Idle below 300 rpm

s300 and SManager software questions & answers
Locked
lporter
Posts: 9
Joined: Mon Jan 16, 2006 3:00 pm

Idle below 300 rpm

Post by lporter » Tue Feb 07, 2006 1:47 pm

I have a P28 ecu in a 1990 crx vtec (british spec) with and odB1 dizzy and 4 wire O2 sensor installed.
The tach reads 950 rpm but the smanager s300 reads between 150-300rpm.
I CAN NOT rev above these values as the engine dies also it will only idle cold. I have replaced the iginion module the fuel pump the regulator.And the car soon as im so angry at spendin weeks of fault finding. Please help I would be so grateful.

Leigh Porter

User avatar
Spunkster
Site Admin
Posts: 18012
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster » Tue Feb 07, 2006 3:28 pm

are there any errror codes when datalogging? Post the calibration and datalog.

lporter
Posts: 9
Joined: Mon Jan 16, 2006 3:00 pm

Base map

Post by lporter » Wed Feb 08, 2006 7:27 am

I am using a base map p30 B16A from the CD with out and modification with no error codes up except the knock sensor and baro as the engine is no equipt with them which i have disabled.
The inject code as i am using stock injects with the resistor box of which i have disabled.
Do you still require a datalog file?

User avatar
Spunkster
Site Admin
Posts: 18012
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Post by Spunkster » Wed Feb 08, 2006 10:36 am

please post the datalog and calibration.

Locked