When car heated up it will not work

s300 and SManager software questions & answers
Locked
eikki
Posts: 13
Joined: Tue Nov 08, 2005 4:35 am

When car heated up it will not work

Post by eikki »

When car heated up he's gonna make ignition cuts or something.. i don't understand..
Can someone explain?
I put here a calibration and datalog also

When heating up all is super.
Attachments
proov.s3d
Datalog
(272.68 KiB) Downloaded 120 times
proov.skl
Calibration
(29.73 KiB) Downloaded 92 times
QUICKSILVER RACING
Posts: 351
Joined: Fri Aug 16, 2002 10:45 pm
Location: PHILIPPINES
Contact:

Post by QUICKSILVER RACING »

Are you using a wideband o2 sensor? something wrong with your calibration. Even the datalog looks funny.

What engine combination are you using?
HONDATA official and sole Distributor in the Philippines.
http://quicksilver.4t.com
+639178954747
eikki
Posts: 13
Joined: Tue Nov 08, 2005 4:35 am

Post by eikki »

QUICKSILVER RACING wrote:Are you using a wideband o2 sensor? something wrong with your calibration. Even the datalog looks funny.

What engine combination are you using?
Yes I'm using wide band.

Engine is NA. Rocket cams 12.7cr aso. Until this morning all was fine.. In the morning i tried to make my idle smoother, but nothing.. I'm not touched the ignition or fuel map. until this kind of problems occurred
i tried with the old calib. also but no effort on that also.
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata »

The ECU internal power regulator is either dying or being overloaded by an external wiring short or a faulty sensor.
Hondata
eikki
Posts: 13
Joined: Tue Nov 08, 2005 4:35 am

Post by eikki »

Hondata wrote:The ECU internal power regulator is either dying or being overloaded by an external wiring short or a faulty sensor.
Now i tried to upload a old basemap with Smanager V1.1.6 and everything works.. It's a miracle..
I don't get it really..

But what is ECU internal power regulator?
Locked