attn Hondata: ECU related issue with s300 socketing
Posted: Sat Mar 24, 2007 7:56 pm
Hondata,
I just received my p28 ecu back from you guys and have been having a new issue that was not present when I ran my s200 previously. I am now getting code 21 vtec spool and have been reading the current other thread about it. I sent my ecu and hondata socketed it for boost and installed the s300. I have swapped out vtec solenoids, traced all my wiring, have the appropriate resistence when following the honda manual troubleshooting, etc. I have the ECU left to rule out. My questions are:
-can you find the issue in my ecu if I send it to you, and if you can....will you repair the problem when located. Is there any way the ecu could have been damaged when doing the prepping/install at hondata?
Is there any other troubleshooting I can do?
Duane
Edmonton, Alberta, Canada.
I just received my p28 ecu back from you guys and have been having a new issue that was not present when I ran my s200 previously. I am now getting code 21 vtec spool and have been reading the current other thread about it. I sent my ecu and hondata socketed it for boost and installed the s300. I have swapped out vtec solenoids, traced all my wiring, have the appropriate resistence when following the honda manual troubleshooting, etc. I have the ECU left to rule out. My questions are:
-can you find the issue in my ecu if I send it to you, and if you can....will you repair the problem when located. Is there any way the ecu could have been damaged when doing the prepping/install at hondata?
Is there any other troubleshooting I can do?
Duane
Edmonton, Alberta, Canada.