Spark plugs

s300 and SManager software questions & answers
Knox
Posts: 122
Joined: Mon Jun 06, 2011 6:01 pm

Re: Spark plugs

Post by Knox » Tue Jan 27, 2015 11:47 am

On thermostat housing. We are using k20 coils.

Spunkster wrote:Where do you have the CPR harness grounded?

User avatar
Spunkster
Site Admin
Posts: 17862
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Spark plugs

Post by Spunkster » Tue Jan 27, 2015 11:50 am

what about the ground for the CPR harness inside the vehicle?

Knox
Posts: 122
Joined: Mon Jun 06, 2011 6:01 pm

Re: Spark plugs

Post by Knox » Sat Jan 31, 2015 1:22 am

I check it yesterday night. Gorund at a23, igntion power at a24, icm at a22 and altc at a16. I did the troubleshooting also every step is ok. Traction control wirings is also wired to a23 and a25 does it cause to this ?


Spunkster wrote:what about the ground for the CPR harness inside the vehicle?

User avatar
Spunkster
Site Admin
Posts: 17862
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Spark plugs

Post by Spunkster » Mon Feb 02, 2015 12:44 pm

Can you start your own thread in the CPR section of the forum: http://www.hondata.com/forum/viewforum.php?f=32

Bauceman
Posts: 25
Joined: Sun Aug 06, 2017 7:17 am

Re: Spark plugs

Post by Bauceman » Sun Aug 06, 2017 6:01 pm

I'm not sure which plugs were installed in my car but I did end up burning a small hole in the mother board of my P72 ecu, is it possible the electrical surge that is sent back from a non resistor plug could cause that? I read earlier in the thread that non-resistors can cause idling problems which is something I'm experiencing now.

User avatar
Spunkster
Site Admin
Posts: 17862
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Spark plugs

Post by Spunkster » Mon Aug 07, 2017 9:27 am

Post a picture of the burned ECU.

Bauceman
Posts: 25
Joined: Sun Aug 06, 2017 7:17 am

Re: Spark plugs

Post by Bauceman » Thu Aug 10, 2017 4:00 pm

I don't have a picture of it but I checked my plugs (same ever since I swapped the engine) and they are a resistor type.

Post Reply