Page 1 of 1

s300 and aem 5 map sensor questions...

Posted: Mon Feb 02, 2009 2:57 pm
by topendusa
are the default settings on the s300 for a 5 bar the same settings for a aem 5 map sensor?
bc my map sensor is reading lower than my autometer manual gauge, and when it gets to low the computer throws a cel for the map sensor
if the sensor calibration is off how do i adjust it and not mess up my tune?

Posted: Tue Feb 03, 2009 8:56 am
by Martian

Posted: Tue Feb 03, 2009 10:20 am
by Spunkster
In Smanager, go to Help, Contents and search for "scalar".

Posted: Mon Mar 02, 2009 11:23 am
by D@nny
im having the same problem since I updated my software. down shift or go into heavy vacuum and the car throws a code for the map sensor and wont rev. cycle the key and it drives fine. also on an aem 5 bar what do we have to do to fix it?

Posted: Tue Mar 03, 2009 9:35 am
by D@nny
scalar for aem 5 bar 1290 off set -645

I cant believe you ask them for the offset and scalar for a popular sensor and they tell you figure it out...typical hondata support.

Posted: Tue Mar 03, 2009 10:15 am
by Hondata
If you have a problem, please follow the posting guidelines and provide a datalog and calibration. Unwarranted abuse will not further your cause.