Page 1 of 1

Hondata s200 led flashing slowly but no cel on

Posted: Sat Apr 05, 2014 3:50 pm
by Type_r_eg
Hey guys I have a s200 with a slowly blinking led but I have no cel on. The cel will come on a few seconds but goes off as it should. I've checked for bad connections but found none. This is a brand new s200 I've bought from someone still in the original box and plastic.

My ecu is a usdm p72 which has already been socketed and chipped running fine before I got the s200. So I got the s200 and hooked up to 4pin cn2, j12 cut, j1 jumped.

The chipped I got it from I had it tuned from phearable.net, could the chip b the problem? It's not a blank chip cause I've been driving on it for a year.

Any help apreciated

Re: Hondata s200 led flashing slowly but no cel on

Posted: Mon Apr 07, 2014 8:19 am
by Type_r_eg
Yeap

Re: Hondata s200 led flashing slowly but no cel on

Posted: Mon Apr 07, 2014 9:51 am
by Spunkster
You need to make sure that the chip you are using was burned with a Hondata program or it will not work with the s200.

Re: Hondata s200 led flashing slowly but no cel on

Posted: Mon Apr 07, 2014 11:27 am
by Type_r_eg
Can I do that myself with a chip programmer or how do I go about that?

Thanks for the reply