Problem running open loop + PLX M300

CivicVTi · Post by **CivicVTi** » Fri Oct 29, 2004 2:48 am

I run open loop and have disabled O2 heater. I get an occasional CEL (primary o2 sensor). Why?

p.s I have not installed a resistor across the o2 heater but I guess disabling O2 heater is equivalent

Post by **Spunkster** » Fri Oct 29, 2004 9:42 am

You still need to install the resistor.

CivicVTi · Post by **CivicVTi** » Fri Oct 29, 2004 10:30 am

OK. Thanks. So disabling o2 heater and installing a resistor would do, right?

highperboi · Post by **highperboi** » Mon Nov 01, 2004 6:03 pm

i have the same problem. So the code 1 throws sometimes means that the o2 is disabled?

turbosi92 · Post by **turbosi92** » Wed Nov 03, 2004 4:59 pm

Spunkster wrote:You still need to install the resistor.

This doesn't help. It is a bug in the software. This doesn't happen on the older version of the Rom Editor.

CivicVTi · Post by **CivicVTi** » Thu Nov 04, 2004 1:59 am

I guess Hondata should solve it in the forthcoming edition of ROM Editor.

DaX · Post by **DaX** » Thu Nov 04, 2004 8:12 am

I think they said they are fixing this in the next release. When is it...sometime around the beginning of 2005?