Page 1 of 1

Engine stalls after revving

Posted: Mon Apr 10, 2006 11:30 am
by ericpay
I just installed a high boost SC kit from JR with the hondata ECU. After starting and revinng a bit the idle of the engine drops dramatically near the point of dying. I tried to ajust the throttle cable but the response of the engine when revving on place still lags. Also when using the engine on the road too hard, it dies the moment i press the clutch pedal when braking.
No engine lights ever!!

Posted: Mon Apr 10, 2006 2:31 pm
by Spunkster
With the idle controller disconnected, what does the engine idle at?

Posted: Tue Apr 11, 2006 1:20 pm
by ericpay
if you are talking about the IAC sensor, once disconnected, not high enough to keep the engine running!

Posted: Tue Apr 11, 2006 2:55 pm
by Spunkster
Follow the Helms manual then for setting the proper idle.

Posted: Wed Apr 12, 2006 11:34 am
by ericpay
the idle is ok when the sensors are removed...it turns at 500 rpm. When i reconnect everything it goes slightly up to 1300 and even 1500 rpm.

Posted: Thu Apr 13, 2006 4:25 am
by ericpay
I obtain few new infos...when i first install the s200, do i have to enter a serial for datalogging??

Posted: Thu Apr 13, 2006 9:40 am
by Spunkster
No, and datalogging would have nothing to do with the idle.