need basemap; h22 89mm 8.5:1 comp turbo 40psi

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
h22power
Posts: 2
Joined: Wed Nov 30, 2011 1:53 am

need basemap; h22 89mm 8.5:1 comp turbo 40psi

Post by h22power »

Looking for a s300 base map up to 10000 rpm for h22 turbo setup.

Statistics are as follows:

-Darton M.I.D sleeves; 89mm bore
-8.5:1 comp. Wiseco pistons
-1mm oversized valves (intake and exhaust)
-11000 rpm springs w/ titanium retainers
-Full race port and polish
-Manley I beam rods
-Skunk2 intake (ported)
-1600cc injectors
-Stock cams
-Stock stroke
-.030' Cometic head gasket
-ARP studs all around
-68mm Blox throttle body

I am looking for map up to 40psi, but anything at 25psi or higher would be nice too.

Thanks

hpmx18
Posts: 211
Joined: Tue Feb 17, 2009 6:47 am
Location: U.S.A

Re: need basemap; h22 89mm 8.5:1 comp turbo 40psi

Post by hpmx18 »

when u say up to 40lbs i hope you not trying to boost that high on a basemap from online
LGMotoring

h22power
Posts: 2
Joined: Wed Nov 30, 2011 1:53 am

Re: need basemap; h22 89mm 8.5:1 comp turbo 40psi

Post by h22power »

no, just something close so i'm not spending thousands of dollars at the dyno. lol

hpmx18
Posts: 211
Joined: Tue Feb 17, 2009 6:47 am
Location: U.S.A

Re: need basemap; h22 89mm 8.5:1 comp turbo 40psi

Post by hpmx18 »

i can make you just to drive but i would boost the car to 40psi tho
LGMotoring

burmese434
Posts: 87
Joined: Fri Feb 12, 2010 7:32 pm
Location: ohio
Contact:

Re: need basemap; h22 89mm 8.5:1 comp turbo 40psi

Post by burmese434 »

Do you self a favor and do your research before you ask for a tune. With 40psi you have to have your motor tuned perfect to hold that kind of pressure. Unless your wanting to build 40psi on a tiny dsm 14b right before the comp and exh wheels come flying out at you.

Post Reply