DOHC ZC Base Map

[mksch666]

Looking for a p29 base map to start tuning a DOHC ZC. Any help would be appreciated.

[Spunkster]

Click New Calibration then select the d16A1 calibration

[gregoyo1]

I just uploaded this calibration on my p28 s300 v2 software 2.2.7. Running a d16a1 in a 1978 civic.
It feels like it will only accelerate or decelerate.. I cant get it to smooth out.. cant pass emissions load test this way..
No dtcs other than vss not installed so its disabled and launch control turned off..

Is the a completely stock pg7 base map I can use to compare with?
I just converted from obd0 pg7 to obd1 p28 with s300 v2, locash ecu adapter, td43u distributor, new 4 wire o2 sensor...

Any help would be greatly appreciated

[Spunkster]

You cannot compare a OBD0 ECU map with an OBD1 map, t hey are completely different. That was a tuned calibration for a D16A1 in an 88 Integra.

You may need additional tuning on the dyno especially at part throttle.

[gregoyo1]

Got it thanks.
I loaded the p28 calibration and it runs great!
Good for getting groceries and driving grandma to work.
Just had to disable vtec and runs great even passed emissions!
Thank you

[gregoyo1]

With the d16a1 tune I definitely could tell has much more power but hard to drive unless dyno tuned as recommended.

[keto06]

Did you try the map in this thread?

viewtopic.php?f=20&t=17111