Page 1 of 1

B20V (B20/B16) Turbo 7lbs Tune

Posted: Sat Jun 04, 2016 5:31 pm
by B20vincali
After a long time of not posting, here is the 332wHP Tune I had on 7lbs boost on E85
All stock internals, bolt ons include:
74mm Skunk2 Pro TB
74mm Skunk2 Ultra Intake Manifold
1000cc Grams Injectors
3" Intercooler Piping
Large Intercooler
Godspeed T3/T4 Turbo
2.5" Down pipe, ran all the way back with muffler, no cat/resonator
7lbs Spring

Any questions, feel free to ask.

Re: B20V (B20/B16) Turbo 7lbs Tune

Posted: Thu Aug 24, 2017 12:20 pm
by h10ndr
Thank you. That is close to our setup. Will try use this as a basemap. ta

Re: B20V (B20/B16) Turbo 7lbs Tune

Posted: Sat Aug 26, 2017 3:07 am
by h10ndr
Aren't these fuel values very large overall when compared to stock ? I would have thought with 1000cc injectors the fuel values would be lower?

Re: B20V (B20/B16) Turbo 7lbs Tune

Posted: Wed Nov 08, 2017 12:21 pm
by Db2 alex
High value fuel because of e85 i think but thanks for posting doing a stock with bolt ons b20v right now going to use this base map to drive the car to the dyno

Re: B20V (B20/B16) Turbo 7lbs Tune

Posted: Wed Jan 24, 2018 7:09 pm
by Zperformance
In my opinion, one of the better tunes i seen so far on the site. jw was this tune on a dyno. Whatsup with the same timing value on vtec?

Re: B20V (B20/B16) Turbo 7lbs Tune

Posted: Tue Feb 06, 2018 5:41 am
by watchout221
quick question could i use this map on my b16a2 and using pump gas?

mods list

dropped compression
eagle rods
head studs
4bar map
SF ram horm
1000cc grams
255 grams
aem rail & fpr
3'DP

Thank you

Re: B20V (B20/B16) Turbo 7lbs Tune

Posted: Tue Feb 06, 2018 7:14 am
by watchout221
watchout221 wrote:
Tue Feb 06, 2018 5:41 am
quick question could i use this map on my b16a2 and using pump gas?

mods list

dropped compression
eagle rods
head studs
4bar map
SF ram horm
1000cc grams
255 grams
aem rail & fpr
3'DP

i fully understand using this at my own risk
Thank you