Page 1 of 1

D13 base maps needed please (bisimoto level 3 cam, ITB)

Posted: Fri Mar 31, 2017 6:09 pm
by SCKAPE
Hi! that is my first post, and i do not now much about ECU tuning...
I tried to find base map in the software but nothing was even close to my setup so please help.

The configuration is:

D13B2 bottom end with D16Z6 cylinder head (is like D16Z6 with capacity 1343cc)

Also:
- camshaft is bisimoto level 3
- ITB based on honda CBR 959
- 4-2-1 manifold + custom exhoust 2,25inch
- hondata s300 V3 (p28)
- 3kg flywheel and 0,8kg crank pulley (if that making any difference...)
- upgraded valves,
- upgraded springs and retailers bisimoto
- cylinder head porting
- 240cc injectors
- fuel pump walbro 255l/h

what I need is just some base maps to start that think and to be able drive 6-7 miles to garage for tune.

Re: D13 base maps needed please (bisimoto level 3 cam, ITB)

Posted: Mon Apr 03, 2017 2:50 am
by SCKAPE
Made base maps by my self based on my crome maps - but as I said - do not know anything about it - just copy everything - can any one have look my maps before ill try start my engine? (btw how can I attach the maps to post?)

Re: D13 base maps needed please (bisimoto level 3 cam, ITB)

Posted: Mon Apr 03, 2017 7:52 am
by SCKAPE
OK... I couldn't wait any longer ;) and started the engine, looks like is working.

however...

i can see that is reading some like 4th column when throttle is close so is going very rich with fuel - can I just switch into ''alpha-n'' (parameters/TPS) mode on primary map without any changes into other parameters and start the engine safety? or I need to do something ales?

I need to only drive that civic to garage safety and not damage the engine on the way, that is all I need from my base maps.

Any one can help?

Re: D13 base maps needed please (bisimoto level 3 cam, ITB)

Posted: Thu Apr 06, 2017 9:32 am
by SCKAPE
enyone??
Maybe even maps for d16z6 with ITB ?