Car won't Idle, Built lsvtec turbo, basemap attached

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
BoostAddict1488
Posts: 4
Joined: Mon Sep 10, 2018 7:31 pm

Car won't Idle, Built lsvtec turbo, basemap attached

Post by BoostAddict1488 » Mon Sep 10, 2018 7:45 pm

Car won't idle after setting up a basemap. Can anyone review this for me? If I hold throttle when starting it will idle. However, very rough and extremely rich, wideband showing 8.06. Thanks in advance.

9.1 cp pistons on manley rods
full bolt on
skunk 2 im and 70mm tb
garrett gt30
4 bar map
fic 1000
gsr head, itr cams
58psi base fuel pressure
rewired walbro 450 high pressure, with 6an feed and return
Attachments
Basemap tps set.skl
(49.71 KiB) Downloaded 56 times

User avatar
Spunkster
Site Admin
Posts: 17744
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Car won't Idle, Built lsvtec turbo, basemap attached

Post by Spunkster » Tue Sep 11, 2018 9:40 am

Have you tried removing fuel to see if you can get it leaner?

BoostAddict1488
Posts: 4
Joined: Mon Sep 10, 2018 7:31 pm

Re: Car won't Idle, Built lsvtec turbo, basemap attached

Post by BoostAddict1488 » Tue Sep 11, 2018 11:03 am

I messed with it some after work last night. Tried pulling -5, then -10 and saw nothing change. Made it all the way to -35% and nothing changed, so quit pulling fuel on it.

User avatar
Spunkster
Site Admin
Posts: 17744
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Car won't Idle, Built lsvtec turbo, basemap attached

Post by Spunkster » Tue Sep 11, 2018 11:10 am

As this sounds like a tuning issue, I would suggest talking to your tuner about this issue and see if they can give you a better basemap to start from.

BoostAddict1488
Posts: 4
Joined: Mon Sep 10, 2018 7:31 pm

Re: Car won't Idle, Built lsvtec turbo, basemap attached

Post by BoostAddict1488 » Tue Sep 11, 2018 12:14 pm

Great....... definitely not the news I was hoping to hear, but I will get back with him.

BoostAddict1488
Posts: 4
Joined: Mon Sep 10, 2018 7:31 pm

Re: Car won't Idle, Built lsvtec turbo, basemap attached

Post by BoostAddict1488 » Sun Sep 23, 2018 1:31 pm

Found that Hondata was not able to display battery voltage. When I changed the deadtimes to 14v, the car runs... I did notice one of the caps inside the ecu has a brown ring, where it appears bad. Does anyone know if bad caps will cause this issue, with not allowing voltage to be seen?

User avatar
Spunkster
Site Admin
Posts: 17744
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Car won't Idle, Built lsvtec turbo, basemap attached

Post by Spunkster » Mon Sep 24, 2018 9:12 am

I would recommend that you replace the capacitors to see if that resolves the issue.

Post Reply