Setting different values Smanager bumps the values up

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Post Reply
Zarvarx
Posts: 1
Joined: Sun May 05, 2019 2:42 pm

Setting different values Smanager bumps the values up

Post by Zarvarx » Sun May 05, 2019 2:51 pm

Alright so I've been doing various tunes for a while now, and while it's never been an issue, I've always noticed the software automatically bumps values up by xx number. Say I'm in the closed loop advanced parameters page, and I set the voltage values to 0.00, 2.50, and 5.00. Well, 0 and 5 stay fine, but 2.50 will automatically bump up to 2.51, and it just sets my OCD off. Anyone have any ideas how to stop it from doing this, or will I just have to deal with it?

User avatar
Spunkster
Site Admin
Posts: 17943
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Setting different values Smanager bumps the values up

Post by Spunkster » Mon May 06, 2019 9:31 am

This is the nature of the values as they are not stored in the ECU as the exact value you can enter. This is completely normal and just how it works.

Post Reply